3D Printing Systems UP MINI User Manual - Cleaning The Nozzle
UP Mini 3D Printer User Manual
IMPORTANT NOTE: Before you enter any new calibration values, always click the
“Reset” button, otherwise the new values get added to the old ones. Before you
new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg.
Next, take down the Front
deviation. Put the exact value into the Z box. If it deviates to the right side,
value to be put into the Z box will be a positive value. If the deviates to the left,
the value to put into the Z box will be a negative value.
Finally, measure the height of Front
40mm if it is not scaled.
“Calibrate dialogue box.
Click “OK” to record all these values and exit the calibrat
Cleaning the nozzle
After a lot of printing, the nozzle may be covered with a layer of oxidized ABS.
When the printer is printing, this oxidized ABS may melt on the nozzle, and may
create discolored spots the model. To avoid this you need to regularly clean the
nozzle.
Firstly, move the platform to the bottom, then do a Withdraw in order to
nozzle to melt the oxidized ABS.
Lastly, use some heat-resistant material, like 100 percent cotton cloth or soft
paper. A pair of tweezers will also be required. Then clip paper or some other
3. Operation
3D Printer User Manual
Before you enter any new calibration values, always click the
“Reset” button, otherwise the new values get added to the old ones. Before you
new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg.
take down the Front Centre ‘L’ shaped component, and measure its
deviation. Put the exact value into the Z box. If it deviates to the right side,
be put into the Z box will be a positive value. If the deviates to the left,
put into the Z box will be a negative value.
Finally, measure the height of Front Center component, which
Enter the exact measured value into the “H” box of the
“Calibrate dialogue box.
Click “OK” to record all these values and exit the calibration window.
Cleaning the nozzle
After a lot of printing, the nozzle may be covered with a layer of oxidized ABS.
rinter is printing, this oxidized ABS may melt on the nozzle, and may
create discolored spots the model. To avoid this you need to regularly clean the
move the platform to the bottom, then do a Withdraw in order to
the oxidized ABS.
resistant material, like 100 percent cotton cloth or soft
paper. A pair of tweezers will also be required. Then clip paper or some other
Operation
42
Before you enter any new calibration values, always click the
“Reset” button, otherwise the new values get added to the old ones. Before you enter any
new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg.
, and measure its
deviation. Put the exact value into the Z box. If it deviates to the right side, the
be put into the Z box will be a positive value. If the deviates to the left,
, which should be
e exact measured value into the “H” box of the
window.
After a lot of printing, the nozzle may be covered with a layer of oxidized ABS.
rinter is printing, this oxidized ABS may melt on the nozzle, and may
create discolored spots the model. To avoid this you need to regularly clean the
move the platform to the bottom, then do a Withdraw in order to heat the
resistant material, like 100 percent cotton cloth or soft
paper. A pair of tweezers will also be required. Then clip paper or some other