3D Systems CUBE Quick Start Manual - page 22

19

NOTE: If Auto Gap is not successful, it is 

recommended that you perform Auto Level 

and Auto Gap again. Select 

AUTO LEVEL

 to 

continue.

NOTE: If Auto Gap is not successful the 

second time, select 

PLATE MAINTENANCE

. 

For more information, refer to the section titled 

PRINT PAD MAINTENANCE. Once the PLATE 

MAINTENANCE procedure has been performed, 

perform Auto Level and Auto Gap.

NOTE: If Auto Gap is still not successful, select 

MANUAL GAP ADJUSTMENT

. Refer to the 

section titled Manual Gap Adjustment for more 

information. Once the Manual Gap Adjustment 

has been performed, note the final reading for 

future reference.

26.  Select 

PRINT

.