3D Systems CUBE Quick Start Manual - page 8
Manual is about: Personal 3D Printer 3rd Generation
of
32
5
6.
Raise the print platform (A) and remove the spacer (B)
from the printer.
7.
Open the accessories box and unpack the material cartridges, the USB mass storage device,
the power supply, cord, and the Cube Glue bottle.
8.
Connect the power supply cable to the power inlet port
(A) on the printer.
NOTE: Ensure the connection is secure. The
cable should lock in place. To remove the
cable, pull back on the outer cable end and
carefully pull it out from the printer.
9.
Connect the power cord to utility power and to the power
supply.
NOTE: Ensure the connection is secure.
10. Power on the Cube by pressing the button next to the touchscreen display.
A
A
B