3D Systems CUBE Quick Start Manual - page 26
Manual is about: Personal 3D Printer 3rd Generation
of
32
23
MAINTENANCE
PRINT PAD MAINTENANCE
Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad or
if the print pad is too shiny.
1.
Select
PLATE MAINTENANCE
.
2.
Using the fine-grit sandpaper, buff the print pad.
NOTE: Refer to the section titled Clean The Print
Pad for specific instructions.
NOTE: Ensure the print pad is clean and dry
before installing it in the printer.
3.
Select the
checkmark
to continue.
4.
Perform the Auto Level and Auto Gap procedures.