3D Systems ProJet 6000 User Manual - page 12

3D Systems, Inc.

EMERGENCY SHUT DOWN USING THE E-STOP

ALERT: In the event of an emergency, immediately press the Emergency Stop switch (E-Stop) .

The emergency stop switch is pressed any time the operator experiences or suspects a machine malfunction . Pressing the E-Stop 

disables the laser and all motors . Pressing the E-Stop does not switch off all power to the machine .

To restart the system after an emergency shut down, rotate the E-Stop switch clockwise to reset it .

FIRST AID AND PROTECTIVE EQUIPMENT

First Aid and Protective Equipment

The following paragraphs provide general first aid procedures and recommendations for protective equipment to minimize the risks from 

print material exposure . If professional medical attention is necessary, take the Material Safety Data Sheet (MSDS) for the exact print 

material involved to the attending physician .

Skin Contact

Wear 100% nitrile gloves and lab coats to avoid skin contact . Should print material come in contact with skin, wash thoroughly with 

soap and cold water and immediately remove contaminated clothing and shoes . If skin is irritated, get medical attention . Dry-clean 

contaminated clothing . Discard contaminated shoes and leather products .

Eye Contact

Safety goggles should be worn to prevent accidental splashes into the eyes. If print material comes in contact with the eye, flush 

immediately with large amounts of water for 15 minutes, avoid sunlight, fluorescent light, and other ultraviolet light, and obtain immediate 

medical attention. Eye wash facilities and a first aid kit should be readily available and close to the print material.

Contact Lenses

If print material splashes into the eye when contact lenses are worn, flush the eye with water immediately. Verify that flushing has 

removed the contact lens from the eye . Protect eyes from light and obtain immediate medical attention . Discard contact lenses that 

come into contact with liquid print material .

12