3D Systems ProJet 6000 User Manual - page 57

3D Systems, Inc.

LEVEL PRINT PLATFORM

1 .  Lower the print platform to the 

Start 

position as follows:

a .  On the front panel, select 

Advanced

b .  Select 

Elevator/Leveler

 .

c .  Press the 

Start 

key .

8 .  The system will pump material from the bottle into the cart reservoir and into the print tray . The GUI will notify the user as additional 

bottles of material are needed .

9 .  Fill times when starting with an empty cart and print tray:

• 

Large print tray - Approximately 45 minutes

• 

Small print tray - Approximately 30 minutes

2 .  To adjust the platform in the X axis, loosen both Y axis locking screws .

57