3M Wireless Tire Pressure Monitoring System Operation Manual - page 3
System operating voltage
System operating current
System adaptable circumstantial temperature range
System operating temperature range
Receiver and Display Unit Specifications
System Installation
The 3M™ Wireless Tire Pressure Monitoring System can be divided into two
major parts. Below is a description of each part's installation methods:
1.Wireless receiver and display unit, installed at the base of the front " A " post
of the driver's seat within the car (as shown in the right figure).
2. Wireless tire sensor and emitter unit, installed within the tire
NOTE: It is strongly recommended that the wireless receiver and
display unit should be installed first, and then the four wireless
tire sensor and emitter units.
3M™ Wireless Tire Pressure Monitoring System Accessories List
Product unit name Quantity
Wireless tire sensor and emitter unit
Tire valves
Tire valve locking screw (NYLOK screw)
Wireless tire pressure monitoring system wheel disk warning sticker
Wireless tire pressure monitoring system product installation labeling sticker
System operation manual
Warranty application letter
Wireless receiver and display unit
Wireless receiver and display unit stand
Power connection cord (3m) & Cigar lighter power connector
The style of the actual cigar lighter power connector being sold may vary.
3M™ Wireless Receiver and Display Unit Installation Guide
A. Plug the power cord connector into the power outlet on the back
of the wireless receiver and display unit
B. Install the receiver and display unit at the base of the " A " post
of the driver's seat or other appropriate locations
1. Remove dusty or greasy substances on the glass surface
near the base of the " A " post
2. Fix the suction-disk side of the TPMS stand to the glass
surface near the bottom of the " A " post
3. Fix the TPMS to the other side of the TPMS stand
B. Plug the cigar lighter connector of the power cord into the cigar
lighter outlet.
3M™ Wireless Tire Pressure Sensor and Emitter Unit Installation Guide
Step Operation
Illustration
Use a bumper jack to have the car body elevated
Remove the tires and mark each tire's location according to the locations of
the sensors
Deflate the tires, remove the tire skins, and then remove the tire valve on each
tire's aluminum rims
(to be replaced by 3M™ Wireless Tire Pressure Monitoring System's standard
tire valve - E)