3M Wireless Tire Pressure Monitoring System Operation Manual - page 6
High Tire Temperature Warning Value Configuration
Step Operation
Illustration
After you finish setting the high tire pressure warning value, the system will automatically
enter the high tire temperature setup mode.
The wireless receiver and display unit will now show the high tire temperature factory
default value (80˚C), the red light indicators for Tire No.1, No.2, No.3 and No.4 (all four
tires, as shown in the illustration), the " C " blue light indicator, and the ""Hi"" directive
characters.
Press the Function button on the front of wireless receiver and display unit to adjust the
high tire temperature warning value. When the tire temperature exceeds this setting,
the system will generate warning signals.
After finish configuring this value, press the Setup button on the top side of the wireless
receiver and display unit once to confirm the high tire temperature setting (and to exit
the setup mode).
If the power of the wireless receiver and display unit is turned off during system configuration, the system will not
make any changes to its settings, and will resume tire monitoring tasks after the power is restored.
The high tire temperature warning value can range from 60 to 99, and its factory default
value is 80.
How to Set up the System after Switching Tire Locations
After the car has been running for a certain distance, it might be necessary to switch tire locations so as to prolong the
lifespan of the tires. Since the sensors of this system are wireless transmission devices, please be sure to perform the
following steps to reset the system after switching tire locations, so as to ensure the actual tire locations and the locations
displayed on the screen are the same.
3M™ Wireless Tire Pressure Monitoring System is equipped with automatic tire location adjustment setup function.
This function can simplify system setup procedure, so that the driver can receive correct pressure and temperature
information from each tire location.
Press and hold both the Setup button and the Function button for 5 seconds to enter the Tire Switching Mode I. Press
the Function button again to enter Mode II, and press the Function button more times to enter Mode III, Mode IV and
Mode V in turn. Press the Function button now to exit Tire Switching Mode and go back to normal display mode.
The following steps will illustrate the setup procedure:
Press the Function button to switch between the five modes. These five modes are, respectively:
NOTE: Green lights indicate the unadjusted tire locations; red lights indicate the adjusted tire locations (after
switching locations); process 1-4 will display repeatedly
Front tires and rear tires switch parallelly (No. 1*No. 2*No. 2*No. 1*No. 3*No. 4*No. 4*No. 3)
Display processes:
the " 1 " displayed at the lower right corner means the system is now in Mode I"
Process 1: " 1 " is displayed at Tire No. 1; " 4 " is displayed at Tire No. 4; both are displayed in green"
Process 2: " 1 " is displayed at Tire No. 2; " 4 " is displayed at Tire No. 3; both are displayed in red"
Process 3: " 2 " is displayed at Tire No. 2; " 3 " is displayed at Tire No. 3; both are displayed in green"
Process 4: " 2 " is displayed at Tire No. 1; " 3 " is displayed at Tire No. 4; both are displayed in red"
After you have done with the Tire Switching Mode, press the Setup button to complete the Mode I setup
procedure and go back to normal display mode."
Process 1** Process 2** Process 3** Process 4
Mode I