3onedata IES7110-2GS-P User manual - page 3
Important notice:
1. Power ON operation: first of all, insert power cable’s terminal
block into device’s power port, then insert power supply plug into
power source
2. Power OFF operation: First off all, unpin power plug, then
strike the terminal block, please take care of operation sequence.
【
DIP switch】
Top panel provided 4 bits DIP switch to do function
configure ( OFF is default factory ) , 1 and 4 keep for future
function. 2 is recovery default factory. 3 is for upgrade. Please
power off and power on when you change the status of DIP
switch.
【
Console port】
IES7110-2GS series provided 1pcs procedure test port based
in serial port. It adopts RJ45 interface, located in top panel, can
configure the CLI command through RJ45 to DB9 female cable.
【
Relay connection】
The relay owns two contacts of the terminal block on the
top pane of IES7010-2GS series. It is used to detect both power
failure and port failure. The two wires attached to contacts form
an open circuit when:
(1) IES7010-2GS series has lost power supply from one of
the DC power inputs.
(2) One of the ports is failure.
【
Communication connector】
10/100BaseT(X) Ethernet port
The pinout of RJ45 port display as below, connect by UTP or
STP. The connect distance is no more than 100m. 100Mbps is
used 120Ωof UTP 5 , 10Mbps is used 120Ωof UTP 3,4,5.
RJ 45 port support automatic MDI/MDI-X operation. Can
connect the PC, Server, Converter and HUB .Pin 1,2,3,6
Corresponding connection in MDI. 1→3, 2→6, 3→1, 6→2 are
used as cross wiring in the MDI-X port of Converter and HUB.
10Base-T/100Base-TX are used in MDI/MDI-X, the define of Pin
in the table as below.
NO.
MDI signal
MDI-X signal
1
TX+
RX+
2
TX-
RX-
3
RX+
TX+
6
RX-
TX-
4, 5, 7, 8
—
—
Note:“TX±”Transmit Data±,“RX±”Receive Data±,“—”Not Use。
MDI (straight-through cable)
MDI-X (Cross over cable)
MDI/MDI-X auto connection makes IES7110-2GS easy to
use for customers without considering the type of network cable.
100Base-FX Fiber port
100Base-FX full-duplex SM or MM port, SC/ST/FC type .The
fiber port must be used in pair, TX (transmit) port connect remote
switch’s RX (receive) port; RX (receive) port connect remote
switch’s TX (transmit) port.
The optical fiber connection supports the line to instruct
enhance the reliability of network effectively
.
Suppose: If you make your own cable, we suggest labeling the
two sides of the same line with the same letter (A-to-A and
B-to-B, shown as below, or A1-to-A2 and B1-to-B2).
1000SFP fiber port(mini-GBIC)
1000BaseSFP fiber port adopts gigabit mini-GBIC
transmission, can choice different SFP module according to
different transfer distance. Fiber interface must use for pair, TX
1
8