4xem WPTZ User Manual - Viewing System Log

- 56 - 

Viewing System Log 

Click on the link on the configuration page to view the system log file. The content of 

the file provides useful information about configuration and connections after system 

boot-up. 

Viewing System Parameters 

Click on this link on the configuration page to view the entire system’s parameter set. 

The content is the same as those in CONFIG.INI. 

Factory Default 

“Factory default” 

Click on this link on the configuration page to restore factory default settings. Any 

changes made so far will be lost and the system will be reset to the initial factory 

settings.  After clicking on the “Restore” button and make confirmation, the system 

will restart and require the installer program to set up the network again. 

“Calibrate” 

Recalibrate the home position to the default center to recover the tolerance caused by 

some external forces. This function is the same as the “Center” button on the Remote 

Controller. Please note that there is no confirming message box after clicking on the 

“Calibrate” button, the Network Camera will calibrate immediately.