- DL manuals
- A&D
- Blood Pressure Monitor
- UA-767PC
- Instruction Manual
A&D UA-767PC Instruction Manual
Summary of UA-767PC
Page 1
Digital blood pressure monitor ua-767pc instruction manual ua-767pex-c wm:pd4000034b.
Page 2: Preliminary Remarks
Preliminary remarks the device conforms to the following requirements: european directive 93/42 eec for medical products act; medical products act; european standards for electrical medical equipment en 60601-1 (general safety provisions), en 60601-1-2 and en 55011 (electromagnetic compatibility); e...
Page 3: Parts Identification
Parts identification 3.
Page 4: Symbols
Symbols 4 symbols function / meaning treatment turns on or off the device ___________ set the clock / does not store the current data ___________ direction guide to install battery ___________ direct current ___________ sn serial number ___________ date of manufacture ___________ type bf: device, cu...
Page 5: Setting The Clock
Setting the clock the ua-767pc blood pressure monitor is equipped with a date and time function. To set the clock on the monitor, follow these steps: press the clock button on the front of the monitor. The blinking digits reflect the year. If they are not currently set on the correct year, press the...
Page 6: Preparation For Measurements
Preparation for measurements 1. Installing / changing the batteries remove the battery cover and insert new batteries into the battery compartment as shown, taking care to observe the proper direction for each battery. Use r6p, lr6 or similar type batteries. If the symbol appears on the display pane...
Page 7: Measurements
Measurements 1. Place the cuff on the arm (preferably the left arm). 2. Set the pressure switch to a value that will be 30 to 40 mmhg above the expected systolic value and press the start button. • when the start button is pressed, all of the display symbols will appear for about one second. • when ...
Page 8: Measurements
Measurements • remain still while the device is in operation. • when a measurement is made with insufficient pressure, the device will pump again to a higher pressure. 4. When measurement has completed, the buzzer sounds and the air is automatically released from the cuff. The systolic pressure, dia...
Page 9: Measurements
Measurements • accurate measurement cannot be made if the exhaust velocity is outside the range of 2 to 5 mmhg. This can be determined by watching the display each time the "measurement in progress" symbol blinks. Note the reading as the "measurement in progress" symbol blinks. 9 notes for proper me...
Page 10: Data In Memory
10 data in memory storing data in memory this device stores up to 126 sets of measurement data in memory automatically. If an error message appears, the measurement data will not be stored. Whether the data will be stored or not after the measurement can be selected as follows: • when the start butt...
Page 11
Transmitting readings to a computer the connected computer is not allowed to be in the patient area. To transmit the readings to a computer, connect the attached communication cable to the data port on the front of the monitor. When the monitor receives the open command, it will be in the ready-to-s...
Page 12
How to make proper measurements how is a proper measurement made? Blood pressure varies depending upon the conditions prevailing at the time of the measurement, consider the following so that the most accurate measurements may be made. 1. In preparation for blood pressure measurement, the subject sh...
Page 13: About Blood Pressure
13 about blood pressure what is blood pressure? The blood pressure is at its highest levels in the large arteries near the heart and drops off towards the peripheral areas of the circulatory system. The blood pressure varies with the beating of the heart. When the heart contracts, forcing the blood ...
Page 14: About Blood Pressure
About blood pressure who blood pressure classifications standards for assessment of high blood pressure, without regard to age, have been established by the world health organization (who), as shown in this chart. Variations in blood pressure individual blood pressures vary greatly both on a daily a...
Page 15: Maintenance
Maintenance do not open the case of the device because it uses delicate electrical components and an intricate air unit that could be damaged. If you can not locate and fix the problem, request service from your supplier, or from the a&d service group. The a&d service group will support authorized s...
Page 16: A&d Co.,ltd.
A&d co.,ltd. A&d co.,ltd. 1-243 asahi, kitamoto-shi, saitama 364-8585 japan 1-243 asahi, kitamoto-shi, saitama 364-8585 japan telephone: [81](48)593-1111 fax: [81](48)593-1119 telephone: [81](48)593-1111 fax: [81](48)593-1119 a&d instruments ltd. A&d instruments ltd. Unit 24/26 blacklands way, abing...