A&D UA-767PC Instruction Manual - page 12
12
Transmitting Readings to a Computer
The connected computer is not permitted to be in the patient area.
To transmit the readings to a computer, connect the attached communication
cable to the data port on the front of the monitor.
When the monitor receives the open command, it will be in the ready-to-send
mode.
When the monitor receives the open command again within five seconds,
“-“ appears one after another in succession and permission will be given to
perform various functions.
Measurement data of the UA-767PC can be monitored with “Monitor Pro” Data
Analysis Software (UA-767P-13) and Printer terminal (TM-2480 series).
For details, refer to the instruction manual.
Note: UA-767P-13 and TM-2480 are sold separately.
Standby mode
Ready-to-send mode
Starts a measurement
Standby mode
Start-to-measure
command
After a
measurement
When the open command is
received again within 5 seconds,
"-" appears one after another.
The command table operation
such as setting time and
obtaining measurement data will
be permitted.
Close command
Receives the
open command