A-Neu Video ANI-PS112 Instruction Manual - page 17
15
OPERATION
AUTO FADE/WIPE Selection
Reset the operation panel to initial mode:
q
→
Press the ON button to enter into AUTO FADE/WIPE mode.
w
→
FADE/WIPE transition time can be adjusted with the TIME control
q
.
e
→
Press the WIPE button
d
to select the wipe effect.
r
→
Press the MIx button
g
to select MIx (FADE) effect.
NOTE: When in AUTO FADE/WIPE mode the Video Slider
5@
is disabled.
DIGITAL EFFECT
Digital effect section which generates digital special effects for the A-bus and B-bus source
video signals. The selected effect(s) can be added to either the A-bus or B-bus at one time.
NOTE: The mosaic effect is not available in the picture-in-picture frame in PIP mode.
1*
/
2#
A-bus, B-bus digital effect ON button.
1(
/
2$
STILL button - creates a still frame.
2)
/
2%
PAINT button - creates a ‘paint’ effect. Repeatedly pressing the PAINT button will
cycle through (3) levels of the effect.
2!
/
2^
NEGATIVE button - creates a negative image.
2@
/
2&
MOSAIC button - creates a ‘pixillated’ effect. Repeatedly pressing the MOSAIC
button will cycle through (3) levels of the effect.
AUDIO MIXER
The Audio can be controlled either separately or in
combination with a video source.
3!
When the AUDIO FOLLOW’s LED illuminate the Audio
may be adjust by Video slider
5@
along with the video.
When the LED is off the Audio will be adjusted by
3$
and
3%
buttons.
3$
Adjusts the A-bus source’s audio level.
3%
Adjusts the B-bus source’s audio level.
3^
AUX: Controls the audio level of the auxiliary input.
3&
MIC: Controls the audio level of the microphone input.
A
NEU
VIDEO