A-Neuvideo HD-44G Instruction Manual - page 15
EDID FUNCTION
EDID FUNCTION SETUP
EDID setup
To change the EDID setup
Step 1.
Press the EDID button
The display will show the currently selected EDID mode
Step 2.
Press SOURCE #1 or #2 button row
The button will fl ash blue and the display will show the current Embedded EDID
Status.
Step 3.
Press the ENTER button
To set EDID mode. The switcher will return to operation mode.
Operation will abort if no keys are pressed within 5 seconds.
Embedded EDID modes
Total 7 EDID Modes
Embedded EDID setup
Press EDID > SOURCE > ENTER
SOURCE #1 or SOURCE #2
Select Embedded EDID :
Mode 1 : FSS
Mode 2 : H24-3D
Mode 3 : H24-3D-M
Mode 4 : H36-3D
Mode 5 : H36-3D-M
Mode 6 : DVI-D 1280x1024-60Hz
Mode 7 : DVI-D 1920x1200-60Hz
To select Embedded EDID mode or LEARNING mode
Press EDID button : The LCM will show the current EDID status.
Repeatedly depressing the source 1 button will cycle up thru the options.
Repeatedly depressing the source 2 button will cycle down thru the options.
RESET
EDID Return To Factory default
How to RESET EDID mode
Press EDID > RECALL > ENTER
RESET
To the FACTORY DEFAULT (1080p-2CH).
Press EDID button : The LCM will show the current EDID status.
Press RECALL button : The LCM will show the RESET EDID.
Press ENTER to confi rm entries.
The EDID will return to FSS mode and resolution 1080p-2CH.
LEARNING EDID
Learning EDID from Destination to Source
Learning EDID setup
Press
EDID > DESTINATION > SOURCE > ENTER
Press EDID > Switcher will LEARN destination EDID and pass the selected
source.
Press: EDID > DESTINATION #1 > Switcher will LEARN destination #1
EDID and pass the selected source.
13