A-Neuvideo HD-44G Instruction Manual - page 15
13
EDID FUNCTION
EDID function Setup
EDID setup
To change the EDID setup
Step 1. Press the EDID button
The display will show the currently selected EDID mode
Step 2. Press SOURCE #1 or #2 button row
The button will flash blue and the display will show the current
Embedded EDID Status.
Step 3. Press the ENTER button
To set
EDID mode.
The switcher will return to operation mode.
Operation will abort if no keys are pressed within 5 seconds.
Embedded EDID modes
Total 7 EDID Modes
Embedded EDID setup
Press
EDID > SOURCE > ENTER
SOURCE #1 or SOURCE #2
Select
Embedded EDID :
Mode 1 : FSS
Mode 2 : H24-3D
Mode 3 : H24-3D-M
Mode 4 : H36-3D
Mode 5 : H36-3D-M
Mode 6 : DVI-D 1280x1024-60Hz
Mode 7 : DVI-D 1920x1200-60Hz
To select
Embedded EDID mode or LEARNING mode
Press
EDID button : The LCM will show the current EDID status.
Repeatedly depressing the
source 1 button will cycle up thru the options.
Repeatedly depressing the
source 2 button will cycle down thru the options.
LEARNING EDID
Learning EDID from Destination to Source
Learning EDID setup
Press
EDID > DESTINATION > SOURCE >
ENTER
Press
EDID > Switcher will LEARN destination EDID and pass the selected source.
Press:
EDID > DESTINATION #1 > Switcher will LEARN destination #1 EDID and
pass the selected source.
NOTE : The already learned EDID cannot be modified. You can only rebuild a new Learning EDID.
For example: When the Source has “Learned” the EDID data from a destination, It will save that EDID information into EPROM and the
EDID data cannot change. Please select new learning destination to sources or change to one of the embedded EDID modes when you
want to remove the learning EDID memory from EPROM.
A
NEU
VIDEO