A-Neuvideo HD-44G Instruction Manual - page 8
6
REAR PANEL
REAR PANEL
A
NEU
VIDEO
q
DC POWER INLET:
The Switcher is fitted with a DC power
plug input connector. Ensure that the used is of an approved type
and is of sufficient current carrying connector capacity with the
correct voltage and connector polarity. 12Volt DC power supply 3A
Max (Center pin positive).
w
IR EXTENDER CONTROL:
Support one of IR Extender.
Extend distance maximum 300 Meters / ~984 feet. When you
plug the External IR extender into the switcher, the front panel
IR receiver remain active.
e
RS-232 CONNECTION:
RS-232 control port to allow for
interfacing to a PC a computer or touch panel control, to the
switcher via this DB-9pin Female connector for serial RS-232
control.
r
INPUTS- 1,2,3, & 4 HDMI:
Connect a signal link of HDMI
direct digital video/audio to this Female HDMI connector. This
connector supports HDMI digital video/audio and DVI digital
video sources.
HDMI Digital Video/Audio, Connector with fix screw
Input 1 ~ Input 4
t
OUTPUTS- 1,2,3,& 4 HDMI:
Connect a signal link of HDMI
direct digital video/audio to this Female HDMI connector. This
connector supports HDMI digital video/audio and DVI digital
video sources.
HDMI Digital Video/Audio, Connector with fix screw
Output 1 ~ Output 4
Power Jack:
DC Jack - Inner OD ᴓ 2.1mm (+ )
Outside OD ᴓ 5.5mm (GND)
Power input - 12VDC, 3A
IR Extender Jack:
Female Jack - inner OD ᴓ 3.5 mm
Remote port :
D-SUB-9pin Female connector
HDMI Digital Video/Audio Connector:
HDMI Female connector.
Note: With the proper adapters, the
switcher can be used with DVI digital video
signals HDCP compliant. DVI does not
support audio.
HDMI Digital Video/Audio Connector:
HDMI Female connector.
Note: With the proper adapters, the
switcher can be used with DVI digital video
signals HDCP compliant. DVI does not
support audio.