A-TOUCH W-Thermo Instruction Manual - page 13
info@a-touch.in.th www.a-touch.in.th
-
The SCENARIO will select directly the mode as defined for the scenario,
regardless of its starting mode.
-
You cannot change the temperature or the ventilation speed with a remote
key.
Associating a key to the thermostat
The programming follows exactly the same rules as programming keys and outputs
on the automation system. Please refer for the Home Automation User Manual for
more details.
To control the thermostat with an automation key proceed as follows:
Press the key (PROG) on the thermostat:
- you will hear one BEEP on the panel.
Now press the key on the automation panel:
- you will hear a long BEEP: from this moment on, the thermostat
will react to that key.
If the key you used is configured to send the command SCENARIO, you must now
store the unit’s operation mode for the scenario:
Put the thermostat in the mode you want it to be in the scenario.
Now hold the SCENARIO key for more than 5 seconds:
- you will hear a long BEEP on the panel: the scenario is stored.
USING THE THERMOSTAT KEYS TO CONTROL AUTOMATION OUTPUTS
If the thermostat is programmed to operate according to the schedule you defined
then you will need very little or even no interaction with it, as it always operates
automatically.
In this case you can decide to use the keys of the thermostat to do something else,
for example switch lights on and off or control shutters or curtains.
The thermostat panel can operate in Thermostat mode (default operation) but also
in Automation mode, where all the keys are normal automation keys (no operation
of the thermostat if they are not programmed to do it).
In Automation mode, the panel has all the keys available:
-
4 direct keys
-
2 horizontal sliding keys
-
2 vertical sliding keys
-
1 multi-touch key (all 4 keys together)
In Thermostat mode, the panel has the 4 direct keys for the operation of the
thermostat, but the sliding and multi-touch keys are still available:
-
2 horizontal sliding keys
-
2 vertical sliding keys
-
1 multi-touch key (all 4 keys together)
To switch between Thermostat mode and Automation mode proceed as follows:
Hold the keys (UP) and (VENT) pressed together for more than 5
seconds on the thermostat panel:
- you will hear 2 short BEEPs on the panel: the display layout
changes to Automation mode.
Now you can use the keys of the thermostat for automation.
21.2º
V1 22º
21.2
º
V1 22º