AAP Elite S series Operating Manual - Programming Your Alarm
16
PROGRAMMING YOUR ALARM
GETTING INTO PROGRAM MODE
There are 2 levels of program mode, CLIENT mode and INSTALLER
mode. Normally the installer will give you access to the CLIENT mode so
you can add, delete, or change the user codes.
In CLIENT mode you can program up to 100 individual User Codes that
may be 1-6 digits in length. Each of the 100 Users can be assigned NO
access, LIMITED access or FULL access to CLIENT mode. A User with
FULL access can change all access codes, change the panel time & date,
change the telephone numbers, change the remote control codes (DTMF),
add or remove radio devices, initiate Walk-test mode and access some
diagnostic features. All of these things can be explained in detail by your
installer.
To get into CLIENT mode provided the system is NOT armed press;
The Program LED with turn ON (LED keypad) or
The LCD Keypad will display “CLIENT : USERS”
If you get a single long beep at this point and the above indications do not
happen it means your code cannot access Program mode.
EXITING PROGRAM MODE
To exit out of program mode press;
Program LED will turn Off or;
Press and hold
ADDING OR DELETING A USER CODE
Once in CLIENT mode, to program a User code you enter the User code
address (Program location 1) then the code address 1-100. For example
to program User # 3 with a code “2580”, key in the following sequence:
(eg P1E3E2580E)
If there is an existing code already at that address it will be displayed on