AAP Elite S series Operating Manual - page 9
9
Zone 1 LED will turn ON.
Bypass LED will now FLASH.
While in the Bypass mode it is possible to Bypass more than one zone.
The example below details how this is done.
To bypass zones 1,9 & 16, key in the following sequence:
Bypass LED will turn ON.
<01,09,16>
Zone LED’s 1,9 & 16 will turn ON.
Bypass LED will now FLASH.
NOTE: To Bypass a zone, the keypad you are using must be as-
signed to the same area as the zone/s you wish to Bypass. If you are
trying to Bypass a zone that is not in the Area assigned to your key-
pad, the panel will not allow you to bypass that zone.
If you are using an LCD keypad to bypass zones, the Bypass button works
the same as the LED keypad but the display shows the numbers as en-
tered e.g. in the example above as you enter in the digits “01”, the display
will show “01”, then if you enter “09”, the display will show “01” & “09” on
the display and finally as you enter “16” the display will show all three
numbers on the screen. The LCD keypad will show up to 5 two digit num-
bers then if you need to bypass more zones it will alternate the display
with the first 5 selections then the next 5, switching between displays at
about a 1 second rate.
The installer can also restrict access to bypass mode by requiring a code
to be entered following the bypass button. If this option is turned on you
must follow the sequence shown below to enter bypass mode.
Once you have accessed bypass mode using your code, the method for
actually bypassing zones is identical to that shown above.
MANUAL PANIC, MEDICAL & FIRE ALARMS
There are three special Manual Alarms that may be triggered from the
keypads. These are a “PANIC” , “FIRE”, and “MEDICAL” alarm. When
using the LED keypad the Panic alarm can be generated by either the sin-