AAP Elite S series Operating Manual - page 7
7
On an LED keypad zone LED’s 1 & 2 will turn ON.
(LED1 = Area A & LED 2 = Area B)
On an LCD keypad the display will show
“Area/s to Disarm” “A B”.
This indicates that both Areas A & B are selected for disarming.
At this point if you press the
will disarm.
If before pressing the
areas prior to disarming you can use buttons 1 or 2 on the keypad.
Button 1 relates to Area A and button 2 relates to Area B.
For example, if you press the number 2, Area B will turn off on the LCD
keypad with the display showing (A -), or zone indicator 2 will turn off on
the LED keypad indicating that only the remaining selection (Area A) will
disarm if you press the
If you don’t do anything the panel will proceed to automatically disarm
both areas in 10 seconds time.
ARMING IN STAY MODE
Stay mode allows you to Arm a pre-selected part of the building. Stay
mode can be used in a residential application to arm parts of the house
that you will not need to go into at night time or in a commercial application
to allow monitoring of an unattended shop front. The Stay mode alarm can
be in the form of a full alarm or possibly a small buzzer (Chime) to warn of
activity in the stay mode coverage area. To arm Stay mode press;
Area A,B or both armed LED’s will FLASH or
Area A,B or both armed LED’s will FLASH.
The panel has two different Stay arming modes and the methods of Arm-
ing are detailed above. The installer will advise you on how they have con-
figured your particular alarm.
If the second option shown above (
arming stay mode and the code and keypad are assigned to both areas
the selective arming method described on page 4 will apply.