AB IPBox 9000HD Manual - page 43
43
(This is to make Cold Off mode)
3. Connect between your PC and STB with USB Cable
4. AC Power On.
5. Press and keep holding the Power button and press + right direction button on the front panel, and you see
“USB UPGRADE” in the front panel.
6. PC detects new hardware device (important) to INSTALL the USB driver
7. Driver Installation Wizard Appears
8. Select ‘install from a list or specific location (advanced)’ and click ‘Next’.
9. Select ‘Include this location in the search’ and click ‘Browse’
10. Designate the folder at C:/Program files/Flash_tools) and click ‘Next’
11. Wizard will search the driver file.
12. Select ‘USB FOR VESTA – c;/windows/inf/vestausb.inf’ and click ‘Next’
12.1. If it asks system file in some case, Browse at c:/program files/Flash_tools/vestausb and click ‘OK’
13. Click ‘Finish’ when it is done.
Important: The order of this procedure is very important; please do follow the instruction step by step.
When Driver is installed successfully, it is ready to download the latest image to the STB (USB download
instructions)
1. Your STB and PC have to be connected by USB cable.
2. The STB has to be in ‘USB upgrade mode.
* For the ‘USB upgrade’ mode, refer to above Driver installation procedure from 1 to 5.
* Tips to make USB upgrade mode without AC Power ON/OFF or power button + + right direction button.
- If you are watching TV now, press Power button + OK button. This status is same as AC OFF/ON
which is so called ‘Cold off’.
And then, Press and keep hold the Power button + right direction button on the front panel until you see
“USB UPGRADE” on the front
3. Run the Flash Tools
4. Select ‘USB’ and check the “USB connected” in the Message box.
5. Designate the image that you want to download to the STB by pressing FILE
6. Click ‘Down’ and Wait for "DONE" on the front display.
7. If you want to download software composed of several parts designate the next part into File window and
press Down button. After finishing press Power button to reboot - your STB will be restarted
Select “ USB”
Select “ proper file”