AB IPBox 9000HD Manual - page 6
6
5.1. Programming the remote control for your TV set.
This Universal type remote control works for both TV and PVR.
There are two ways to program the remote control; Automatic Code Search and Direct Entry.
5.1.1 Using automatic code search
1. Turn on the component (TV) you want to control.
2. Press and hold the TV button until the LED (TV button) turns on red, then release the key.
3. Point the remote at the component (TV), press and release the UP (
) button, and then wait three
seconds or until the LED stops flashing.
At this point the remote control is searching for the correct code to program. If, after three seconds, the
component (TV) you want to control does not turn off, press and release UP (
) button again to make
the remote to search the next set of codes.
4. If the component you want to control does turn off; Press and release OK button, then the LED blinks
three times.
5.1.2. Using direct entry method
1. Turn on the component (TV) you want to control.
2. Locate the Code List (refer to code list on the page 59). Find your TV brand that you want to control.
3. Press and hold the TV button until the LED on the remote control turns on red, then release the key.
4. Enter 3-digit code from the code list, then the LED blinks three times.
5. If you get no response, repeat these steps using the next code listed for your TV brand until the
component responds to the remote control command.
5.1.3. Locking the volume control.
Locking the volume controls to a single device makes it easier to control volume, without having an
unexpected volume change. If you lock the remote's volume controls to the TV set, you will be always
able to change the volume to the level you want, without having adjusting it twice on multiple devices.
If you want to lock the volume for the TV system;
1. Press and hold the
STB
component key until the LED on the remote control turns on.
2. Enter 3-digit code,
9 9 9 .
3. Press and release the
STB
component key, then the LED blinks three times.
5.1.4. Unlocking the volume control.
If you want to unlock the volume for the
STB
component;
1. Press and hold the
STB
button until the LED on the remote control turns on.
2. Enter 3-digit code,
9 9 9
.
3. Press and release the
STB
component key, then the LED blinks three times.
NOTICE: Find the TV brand code list on the page 44.