ABB 266FF Operating Instructions Manual - page 3
2600T Series Pressure transmitters |
OI/266/FF-EN Rev. B 3
Contents
Index
1. Introduction ........................................................... 5
1.1 Instruction manual structure ......................................5
1.2 Models covered by this manual..................................5
1.3 Product description ...................................................5
2. Safety .................................................................... 6
2.1 General safety information .........................................6
2.2 Improper use ............................................................6
2.3 Technical limit values .................................................6
2.4 Warranty prevision ....................................................6
2.5 Use of instruction ......................................................6
2.6 Operator liability ........................................................7
2.7 Qualified personnel ...................................................7
2.8 Returning devices .....................................................7
2.9 Disposal ...................................................................7
2.10 Information on WEEE Directive 2002/96/EC .............7
2.11 Transport and storage .............................................7
2.12 Safety information for electrical installation ...............7
2.13 Safety information for inspection and maintenance ...7
3. Transmitter overview ............................................. 8
3.1 Transmitter components overview ..............................8
3.2 Range & Span consideration .....................................9
4. Opening the box .................................................. 10
4.1 Identification ...........................................................10
4.2 Optional wired-on SST plate (I1) ..............................11
4.3 Handling .................................................................11
4.4 Storage ..................................................................11
5. Mounting ............................................................. 12
5.1 General ..................................................................12
5.2 IP protection & designation ......................................12
5.3 Mounting the transmitter .........................................12
5.3.1 Transmitter factory configuration consideration .12
5.3.2 Hazardous area considerations ........................12
5.4 Pressure Equipment Directive (PED) (97/23/CE) ........13
5.4.1 Devices with PS >200 ......................................13
5.4.2 Devices with PS
≤
200 bar ................................13
5.5 Mounting a DP sensor transmitter ...........................13
5.5.1 Bracket mounting (optional) ..............................14
5.5.2 B2 Pipe and wall mounting bracket details ........17
5.5.3 B5 Flat type bracket details ..............................18
5.6 Mounting a P style pressure transmitter ...................19
5.6.1 B1 and B2 Barrel housing bracket details ..........21
5.6.2 B2 DIN Housing bracket details ........................22
5.7 Transmitter housing rotation ....................................23
5.8 Integral display rotation ...........................................23
5.9 Impulse piping connection for standard instruments .23
5.10 Process connections considerations ......................24
5.11 Kynar inserts connection .......................................24
5.12 Screw torques for models with Kynar inserts ..........24
5.13 Installation recommendations ................................25
5.13.1 Steam or clean liquids flow measurement ........25
5.13.2 Gas or liquid flow measurement ......................25
5.13.3 Level measurements on closed tanks (dry leg) .26
5.13.4 Level measurement on closed tanks (wet leg) ..26
5.13.5 Liquid level measurement with open tanks .......26
5.13.6 Pressure measurement of a tank .....................27
5.13.7 Pressure measurement of a liquid in a pipe ......27
5.13.8 Pressure measurement of vapor in a pipe ........28
5.13.9 Pressure measurement of a gas in a pipe ........28
6. Device introduction ............................................. 29
6.1 Fieldbus Foundation communication protocol ...........29
6.2 Feature overview .....................................................29
6.3 Registration details .................................................29
6.4 FF device structure .................................................29
6.5 Device Application Process (DAP) ............................29
6.6 Control Application Process (CAP) ...........................29