ABB C1900 Series Installation Manual - page 3
1
MODBUS (RTU)
Serial Adaptors
Serial Connections
Programming Pages
ASCII Tables
Part No.
IM/C1900–MOD
Flow Totalisation
Ramp/Soak Profile
Maths Functions
Timer Functions
Part No.
IM/C1900–ADV
ADVANCED SOFTWARE
OPTIONS
SPECIFICATION SHT.
Full Specification
Part No.
SS C1900
Part No.
IM/C1900—INS
INSTALLATION
Product Identification
Siting
Mounting
Electrical Connections
Installation Record
Recorders and Controllers
PROGRAMMING
Part No.
IM/C1900–PGR
Basic Config. Level
Advanced Config. Level
OPERATION
Setting Up
Displays & Controls
Operating Level
Simple Fault Finding
Part No.
IM/C1900–OGR
Recorders Only
PROGRAMMING
Part No.
IM/C1900–PGC
Basic Config. Level
Advanced Config. Level
OPERATION
Setting Up
Displays & Controls
Operating Level
Simple Fault Finding
Part No.
IM/C1900–OGC
Control Config. Level
Controllers Only
A — Standard Manuals
B — Supplementary Manuals
1
INTRODUCTION
Section
Page
1
INTRODUCTION ........................................................... 1
2
PREPARATION ............................................................. 2
2.1
Accessories ........................................................ 2
2.2
Checking the Code Number ............................... 2
2.2.1
Non-upgradeable Version ...................... 2
3
MECHANICAL INSTALLATION .................................... 3
3.1
Siting .................................................................. 3
3.2
Mounting ............................................................ 3
3.2.1
Wall-/Pipe-Mounting .............................. 4
3.2.2
Panel Mounting ..................................... 5
4
ELECTRICAL INSTALLATION ...................................... 6
4.1
Identifying the Input/Output Modules .................. 7
4.2
Channel Connections ......................................... 7
4.2.1
Selecting the Analog Input Type(s) ......... 8
4.2.2
Voltage and Current .............................. 9
4.2.3
2-wire Transmitter Input ......................... 9
4.2.4
Thermocouple ....................................... 9
4.2.5
Resistance Thermometer (RTD) ............. 9
4.2.6
Logic Inputs .......................................... 9
4.2.7
Analog Output ....................................... 9
4.2.8
Relay Output ........................................ 9
4.2.9
Motorized Valve ................................... 10
4.3
Module Connections ......................................... 11
4.3.1
Standard I/O or Analog + Relay
(Module Types 1, 2 and 7) ................... 11
4.3.2
Four Relay Module (Module Type 3) ..... 11
4.3.3
Eight Digital Inputs or Outputs
(Module Types 4 and 5 respectively) ... 11
4.4
Power Supply Selection and
AC Connections ............................................... 13
5
INSTALLATION RECORD ........................................... 13
The series of COMMANDER 1900 instruction manuals is shown
in Fig. 1.1. The
Standard Manuals
, including the specification
sheet, are supplied with all instruments. The
Supplementary
Manuals
supplied depend on the specification of the instrument.
This manual includes an
Installation Record
which should be
completed as a log of the electrical installation. The record is
useful when carrying out initial instrument programming and can
be retained for future reference.
Fig. 1.1 COMMANDER 1900 Documentation
CONTENTS