ABB C1900 Series Installation Manual - page 9
7
Additional
Functions
Channel 3
(Blue Pen)
Module Positions
1 2
3
4
5
6
Channel 4
(Black Pen, Violet Event
Pen or Additional Functions)
Not available on
non-upgradeable
version
See
Note
below
Additional
Functions
Channel 2
(Green Pen)
Channel 1
(Red Pen)
4.1
Identifying the Input/Output Modules – Fig. 4.2
To gain access to the modules, open the door and chassis – see
Fig. 2.2. There are six module positions as shown in
Fig. 4.2.
4.2
Channel Connections
Channel 1 connections
are made directly to the terminal block
mounted on the motherboard.
Other Channel connections
are made to standard I/O modules,
fitted in positions 2, 3 or 4 – see Fig. 4.2.
Warning. The maximum channel to channel
voltage (between any 2 channels) must not exceed
500V DC.
Notes.
• Module positions can also be used for
additional I/O modules (module types 1 and
2) for use with math functions.
• The module type is marked on the
component side of the PCB Refer to Table
2.1 for the module types and module
position options.
Fig. 4.2 Module Positions and Functions
4
ELECTRICAL INSTALLATION…