ABB VersaRupter Installation, Operation And Maintanance Manual - page 13
VersaRupter MV Indoor Switch | Installation and Operation Manual
13
Mounting the Open Fuse Auxiliary Switch
5. Rotate the switch out of position and remove the white
disk. Install the long bolt and two nuts into the marked
hole from the previous step as in figure 15.
6. Re-install the white disk and switch back onto the A-
mechanism. Rotate the white disk until it reaches its max-
imum rotation and contacts the switch as in figure 16. An
audible click should be heard. If not, remove the white
disk and move the long bolt and nuts to the appropriate
hole. Once adjusted properly, secure the switch with a 13
mm socket and Phillips screw driver.
7. Install the cir-clip onto the half-moon shaft to secure the
white disk as shown in figure 17.
Figure 15
Figure 16
Figure 17