ABB VersaRupter Installation, Operation And Maintanance Manual - page 32
Manual is about: MV Indoor Switch 4.76-38 kV, 200-1200 A, 40 & 61 kA
of
83
VersaRupter MV Indoor Switch | Installation and Operation Manual
32
Installing the Bottom Mounted Fuse Base with Fuse Tripping
4. Install the release rod (11) in the lever (13) as shown
in figure 72.
5. Mount the drive ring (2) to the release shaft (1) on the
right hand side as shown in figure 73.
6. Mount the disk (3) onto the A-mech shaft (4) found on
the operating mechanism as shown in figure 74.
7. Slide the bearing (5) and washer (6) onto the left side
of the release shaft (1), engage the release shaft (1)
with the disk (3), and place the left side of the release
shaft (1) into the hole found on the left side of the
VersaRupter frame. Refer to figure 75.
Figure 72
Figure 73
Figure 74
Figure 75