AbelCine PCU2+ Owner's Manual - page 13
BT: Not Paired
Hold
D
for 5 seconds to begin
searching for cameras within range.
Note: The name shown for each
camera is the MAC address printed
on the side of the Bluetooth dongle.
Technically the PCU2+ pairs with the
dongle, not the camera.
To pair the PCU2+ with the camera shown,
press
D
. To exit without pairing, press
B
.
BT: Pairing
The PCU2+ will remember the most recently
paired dongle and will automatically connect
when it is within range. If you need to connect
to a different dongle, establish a link in the
next page.
After several seconds of searching, a
connection screen will appear showing the
first camera found (if any). If more than one
camera is found, press
C
to see the next
camera.
BT: Paired
The PCU2+ can wirelessly control a
Phantom camera from a distance of
up to 100 meters when used with a
Vision Research Bluetooth dongle.
7
Wireless Operation
LEFT VIEW
FRONT VIEW
RIGHT VIEW
LEFT VIEW
FRONT VIEW
RIGHT VIEW
WIRELESS
WIRELESS
ENABLED
LED
Illuminates when
Bluetooth is enabled.
When Bluetooth
is enabled, wired
operation is not
possible.
To enable Bluetooth, go to the ‘Bluetooth’
page of the Advanced menu. The blue LED
labeled
ENBL
will illuminate to indicate
that Bluetooth is turned on.
Press
D
to toggle Bluetooth. When
Bluetooth is enabled, the wired camera
connection is disabled.
Make sure the antenna is screwed on and
internal battery is charged. When the
PCU2+ is not powered from a cable, the
internal battery will provide power for up
to 30 continuous hours on a full charge
(see page 27).
WIRELESS
CONNECTED LED
Illuminates when
there is an active
connection between
the PCU2+ and the
Bluetooth dongle.
24
25