Abi IMAGE IQBoardPS User Manual - page 5
- 5 -
Warning prior to Installation
z Do not look directly at the projector light.
z Don’t leave cables that may causing tripping
. If the cables must be put on the floor,
straighten and tape them to the floor using “gaffer” tape.
Environment
z Please do not put any electrical
wiring
within 50cm of the EWB. Avoid producing
and electrical or magnetic disturbance that may
affect the
normal usage of the
equipment.
z Avoid using the IWB in dusty, damp or smog bound environments.
z Read the IWB Maintenance section (p.19) prior to installation and use.
Projecting
z Use the projector output format that matches the IQBoardA that is being used..
z When
ceiling mounting the projector, please make
the projector lens level with the
top edge of the EWB. The centre of the lens must on the horizontal centre of the
Whiteboard. The distance from the screen is determined by the optics of the
projector. Keystone correction should be used if necessary.
z The Image of the projector must be in the center of the effective area, as Figure 2-
1.
The blue area is the effective
area of Whiteboard. (The
image should not be on the
pen colour hot keys)
Transportation
z It is suggested to repack the digital interactive whiteboard with the original
packaging provided when long distance transportation is necessary. If the
original package is unavailable, insert as much padding as possible between
all the components to avoid damage from vibration or crash.
Consumables
z Make sure only genuine IMAGE IWB or components are used.
Extended Cable
z When
the USB data line needs to be extended, please use shielded twisted pair
(Max length should be less than 30m, otherwise there may be loss of signal).