Abi IMAGE IQBoardPS User Manual - page 6
- 9 -
2: Installation and Uninstall of Software
Install Interactive software
Note: There are 2 software programs to load. Please double click on the software
in the CD supplied, and follow the instructions:
a.
IQBoard ET&PS Drivers - Board drivers and calibration software
b.
IQ INteractive Software - Board Presentation software (if software purchased
with board)
(1)
Do not connect the data line before installing the software.
(2)
Lowest Specification of PC:Pentium III (500MHz) or above recommended,
128
MB
RAM, 1G HDD, one USB port, Resolution: 1024×768 (16bit high color or above)
(3)
System Requirement: MS Windows 98/Me/2000/XP
(4)
Some special functions may be limited by the OS used.
Run the “Setup.exe” on the CD and install it according the following steps:
Please select “Yes, I agree to this agreement” in the “Software License Agreement”, and
enter the user information and product register number when installing. Then finish the
installation according to the prompt on the Installation Interface.
Uninstall
Click Start > Programs > Returnstar Electronic Whiteboard Software >Uninstall to uninstall
this software. You also can open “Control Panel”, select “Add/Remove Programs”, and in
the list of currently installed Programs, select “Returnstar Electronic Whiteboard Software”,
then press the “Change/Remove” button to remove.
3: Connect the Data Line
The connection from the PC to the Board is via the cable supplied with the board. The PC
connection is via USB and the power to the board is supplied via the USB. Ensure that the
push connectors from the board pen tray to the board are properly connected also. If installing
succeeds, the
indicator light of digital EWB will be green; if the indicator light is not lit,
the data line connection has not been successful; if it is red, the connection is not stable.
See FAQs for help with any problem.
4. Board Orientation:
The whiteboard must be oriented (calibrated) so that the pen or finger is correctly located by
the board software. To do this, click on the “Position” button in the IQ Board PS program. The
whiteboard must be connected to your PC, and the projector must be projecting the PC
image onto the board to be able to use the calibration software. A blank white screen will
be displayed with a red cross hair. Click on the centre of the cross hair
with the stylus pen supplied. Repeat the
procedure as the cross hairs move around the board
(total of 9 or 20 cross hair locations depending on choice).
When pressing, the pen must be vertical to the EWB.
If you click in the wrong position, you need to start the
calibration procedure again. After completing
the calibration, it will shut off automatically and the
board is ready to use.