ABRIVO X-EO User Quick Reference Manual - page 3
18
Making an E-Response Help Call
If programmed, X- EO provides emergency notification
to a group of telephones or paging system.
♦
Go off hook and do not dial for more than 10
seconds,
or
Go off hook and begin dialing a system exten-
sion. Between digits pause for more than 10
seconds,
or
At ICM dial tone dial the E-Response Group
access number.
♦
The system will initiate an E-Response Help Call
to the stations in your E-Response Group and/or
a paging system.
Universal Night Answer
If you need to pick up an incoming call when the sys-
tem is in the night mode
♦
Lift receiver
♦
Press [FEAT] button and dial 36
or
♦
Press the [UNIVERSAL NIGHT ANSWER] but-
ton (if assigned)
You are connected with the incoming call
3
HOLD/DND (Hold/Do Not Disturb) - This key is used
to put a call on Hold or to set the Do Not Disturb func-
tion to prevent any calls from getting through or ring-
ing at your extension.
Handset Volume Control - The handset volume
control key allows you to adjust the handset volume to
one of three levels. Pressing the button will toggle
between the three volume levels.
Speaker Volume Control - The speaker volume
control key allows you to adjust the volume control of
the speaker when using speakerphone. Pressing the
[+] key raises the volume to one of nine settings.
Pressing the [-]will decrease the volume.
Ringer Volume Control - Pressing the ringer volume
control button allows you to adjust the ringer volume
to one of four levels.
[Mute] Key - When talking using the handset, press-
ing the [Mute ] key mutes the handset transmitter. If
using the speakerphone, pressing the [Mute ] key
mutes the station microphone. When using the head-
set jack, the [Mute ] key mutes the transmitter on the
headset.
ICM - The intercom system is the internal network
used to communicate between the telephone exten-
sions in your
X-EO system. Pressing the [ICM ] key connects you to
an intercom line for conversation with other exten-
sions.
Making an Outgoing Call
♦
Lift the receiver
♦
Press an outside line button. You will hear a dial
tone.
♦
Dial telephone number
Make a dialing mistake?
♦
Press the [FLASH] button to get new dial tone
♦
Dial again
Receiving an Incoming Call
♦
When your phone rings and lamp flashes
♦
Lift the receiver to connect the call
If your phone does not connect you to the call
automatically
When your phone rings and lamp flashes
♦
Lift the receiver
♦
Press the button with the flashing lamp to
connect the call