ABS GBA15 Instructions For Use Manual - page 16
Step 7
Height adjustment of the activation handle*
Check when wearing the backpack if the activation handle is
positioned in a way that works for you . Usually that is the case,
if not, the handle attachment can be adjusted to the appropriate
height . The proper position of the activation handle should be
between chest and shoulder . In order to adjust the height, open
and unfold the Velcro fastener, detach the plastic grommet
and thread it through the little straps one position up or down .
Reattach the handle plate to the newly positioned grommet and
reattach and secure the Velcro fastener .
Make sure that the activation handle is not obstructed by
clothing and that it can be easily reached.
A retail shop will be able to attach the activation handle on the
right hand strap if so desired by left-handed clients . A special
handle plate is needed .*
* Not available for all Partner models
Step 8
Remove activation handle
In order to remove the handle, push the coupler upwards . The
activation handle will pop out without you pulling on it . Do not
pull the charged activation
handle, the system will be
activated! If you are not able
to remove the activation
handle refer to point 13 .1 .
Remove the handle when
ABS backpack is not in use
and store it in the pocket
located at the hip belt .
Step 9
Practice activation
We want you to feel 100% comfortable with the ABS-System .
We therefore strongly recommend that you practice the triggering
as part of your training so that the functional principle can be
demonstrated as realistically as possible .
Please ensure that during the practice activation the distance to
people and objects is approximately 1 m (3 .28 feet) in order to
avoid adverse affects . Activate the handle with a strong, rapid pull .
English
26
140325_ABS_GBA_2014_Innenteil_RZ.indd 26
25.03.14 12:59
The required activation force equals approx . 8 kg (17 .64 lb; 80 N) .
The airbags will inflate within 2-3 seconds .
Attention! Background noise
after inflation is caused by
the release valve, which
automatically equalizes the
pressure . The inflation of the
airbags varies according to
the outside temperature and
elevation .
Step 10
Deflate airbags
Grab with both hands under
the net cover over the valve .
Now fold up the red cover and
press the release valve in the
center of the black suction
and release valve . At the same
time, compress the airbag until
it is completely empty .
Step 11
Folding airbags
Attention! Improper folding
will result in poor opening of
the airbags. This can lead to
malfunction and damage to
the backpack!
Therefore please fold the air-
bags according to the following
instructions .
1 . Lie the airbags down with
the suction and release valve
facing the ground . The smooth
side of the airbag should be
facing up .
2 . Fold the upper part of the
airbag to the level of the airbag
compartment .
3 . Now fold the bottom part of
the airbag . The airbag width
must correspond to the width
of the airbag compartment .
English
27
1
2
3
140325_ABS_GBA_2014_Innenteil_RZ.indd 27
25.03.14 12:59