Abus RWM450 User Manual - Setting Up

– 40 –

Se

tti

ng

 U

P

SETTING UP AND ESTABLISHING THE 

NETWORK 

Setting Up

Notes on networking the radio-inter-

linked smoke alarm (abbreviated here 

to RISA or “alarm”):

The alarm should only be activated as 

described in this manual:

Activation and setup of radio groups:

  The alarms must ONLY be set up

• singly

• one after another 

• in direct proximity to their intended 

  installation position (in the room in 

  which each unit will be used).

Do not network alarms that are less 

than 1 m apart – signal overlap – 

faults in network setup

> 0

.50

< 1

.00

> 20°

> 20°

> 1.00

1/2

1/2

> 20°

< 1.00

> 0

.50

< 1

.00

-   Platforms/galleries <16 m

2

 and at least 2 m long and 

wide: 1 detector

  • over 16 m

2

: install additional detectors

-   Roof slopes (slopes below 20° are considered flat 

ceilings): 

In the event of a fire, this device quickly detects the 

build-up of smoke and also the associated rise in 

temperature in the room. In order to warn you in good 

time, it then emits a loud alarm sound. If you decide 

that there is no real need to escape the building you 

can temporarily deactivate this signal (for approx. 

10 minutes), or temporarily disable it before sounding, 

by gently pressing the Test/Stop button (Fig. 1, IV). We 

recommend that you then provide good ventilation to 

the room to prevent the alarm being triggered again.