Abus RWM450 User Manual - And Possible Damage to The
– 54 –
Be certain to note that this is a
very strong fixing; the unit can
only be removed with great effort
and possible damage to the
mounting site and to the device.
We accept no liability for any
damage incurred.
For this adhesive mounting, only
the adhesive supplied may be
used.
The mounting site must be
• firm
• dry
• free of dust, grease or
loose paint, etc.
Application:
a) Remove the information sticker
and the protective film from the
self-adhesive surface (Fig. 3) of the
magnetic holder.
b) Press the adhesive surface of the
magnetic holder for approx. 10
seconds firmly onto the mounting
surface.
c) Remove the first protective film
from the thin double-sided
adhesive film and press this firmly,
smoothly and flush onto the entire
metal surface of the smoke alarm
unit.
d) Now remove the second protective
film of the thin double-sided adhe-
sive film and place the unit with
gentle pressure onto the pre-moun-
ted magnetic holder.
e) The adhesive bond will reach its
final strength after approx. 72 hours.
2. Drilled Hole Mounting
Application:
a) Using an 8-mm drill bit, drill a hole
at the installation position (take
care not to strike any electric cables,
etc. underneath).
b) Insert the 8-mm wall plug into
the hole.
c) Push the 5-mm countersunk screw
provided through the bottom of
the magnetic holder and into the
hole (Fig. 4).
d) Tighten the screw into the wall
plug so that the screw sits flush
and is fully sunk into the recess
provided for it in the magnetic
holder.