Accelerated 6200-FX User manual - page 8
8 of 14
Copyright Accelerated Concepts, Inc. © 2013
6200-FX Addendum
Administration:
Firmware Image (3G) – select the 3G firmware version to use from the drop-‐down list.
Firmware Image (4G) – select the 4G firmware version to use from drop-‐down list.
Firmware Image (DX) -‐ specify the firmware image name for 6300-‐DX devices.
Config Server – the IP address or domain name or the configuration server to be used
for these devices. Multiple addresses can be entered and should be separated by
commas.
Configuration Change Causes Reboot – this check box indicates whether the device
should automatically restart itself when a new configuration is loaded. If left blank the
device will need to be manually restarted or wait for a nightly reboot.
Firmware Server – the IP address or name from which the device is to load its latest
firmware. Only one address may be specified.
Ignore Unsolicited Inbound – this check box allows you to turn the units firewall ON.
When activated all unsolicited inbound traffic will be ignored.
Ping Test List – allows you to specify a list of IP addresses to test for network
connectivity. The unit will periodically ping the entries in the list to determine its health.
If an address cannot be reached a recovery process will be initiated. The list should
contain at least one address. The default is 8.8.8.8.
Reboot Nightly? – this check box lets you specify if the unit should restart on a nightly
basis.
SMS Check Frequency – the Netbridge uses SMS as a backup method for management
and recovery. This field allows you to specify how often the unit will check for inbound
messages. The format is in XXU where XX is a numeral from 0 -‐ 59 and U is the unit of
measure M – minutes, H – hours, D – days.
Upload Server – the IP address of the server to receive the devices syslogs.
Enable/Disable Watchdog – allows you to indicate whether the unit should enable its
watchdog timer to check for error conditions. The timer is enabled by default.