Accupipe Wicks CM-100 Quick Reference Manual - 1. Controls and Connections
Page 3
WICKS
CM-100
Pipe Organ Module
ENGLISH
1. CONTROLS AND CONNECTIONS
1. CONTROLS AND CONNECTIONS
1.1 Description of the front p
1.1 Description of the front p
anel
anel
o
VOICE
key: Selection key used to access the menus for modifying everything relating to the voice, such
as the timbre parameters, replacement of voices in the stops, the levels of each voice, and so on.
o
SETUP
key: Press this key to access the menu for modifying the CM-100's general parameters, such
as the MIDI channel, tremulant, reverb, etc. settings.
o
DEMO
mode: In DEMO mode you can play back eight short pieces of music (which the instrument
plays without any assistance from you) to demonstrate the instrument's timbre qualities: to access this
mode, press the VOICE and SETUP keys simultaneously.
o
DATA
rotary encoder: The data input device. Once you have selected the parameter for modification
using the cursor keys, you can adjust its value by turning this knob. Turn the encoder clockwise to
increase the value, or anticlockwise to decrease.
o
CURSOR
S
,
T
,
W
,
X
keys: these buttons allow you to move the cursor around the video page on the
display and select the various parameters for modification. What's more, the
S
and
T
buttons have
LEDs which come on to indicate the availability of a video page before and/or after the one displayed.
Press the relative button to display the video page you require.
o
ENTER
key: button which confirms the selection of a function, a value or a procedure.
o
EXIT
key: button for exiting the current video page or function. Pressing this key also aborts any pro-
cedures in progress (where permitted).
o
VOLUME
trimmer: regulates the instrument's general volume.
o
REVERB
trimmer: regulates the level of the Reverb effect. When the trimmer is turned to the minimum
(lowest) setting, the effect is disabled.
o
SET
key: Press this key to enable the saving of VOICE MEMORIES (see next point).