Airius System 10 Operating And Installation Manual - page 6
Always hold the AIRIUS SYSTEM unit by the Bail/Crosspiece to avoid injury from
moving parts.
To confirm electrical continuity, if possible, Plug the AIRIUS SYSTEM into a energized
outlet, similar to the outlet installed in the ceiling, on the ground before permanently
mounting the AIRIUS SYSTEM in the ceiling.
NOTE:
The AIRIUS SYSTEM can be wired directly to a junction box but only by a
qualified electrician or similarly qualified person. Always ensure that all relevant local
regulations/electrical codes are understood and followed with care - if in any doubt
seek expert guidance. Check Local Electrical Codes. The preferred system is designed
with a plug for easy service and cleaning (see Cleaning). An On-Off switch must be
installed in the circuit to be able to disable the power to prevent electrical hazard
when servicing the appliance.
BAIL aka: HANDLE or CROSS-PIECE
The BAIL is attached with two
1/4”
x 20 x 1” TORX® head machine screws. The screws
can be loosened to adjust the bail to the vertical so that it can be suspended from the
ceiling on the provided Eyebolt.
The Eyebolt is installed through a
5/16
” hole in the bail with locking nuts and washers.
NOTE: The Bail may be angled, as it is ratcheted for special situations where a vertical
air column is undesirable and an angled column would be more effective.
5. HANGING THE AIRIUS SYSTEM
The AIRIUS SYSTEM is designed to be hung vertically as high in the ceiling of the
facility as possible with the nozzle pointing to the floor for maximum thermal
equalization.
The AIRIUS SYSTEM is designed to hang vertically and freely from the ceiling on
professionally installed hardware, capable of supporting a minimum of four times the
weight, 12 lb (5.4 Kilo) of the AIRIUS SYSTEM unit. Example -
1/4
” (7mm) diameter
steel bolt is rated at 60 lb (27 Kilo) Load.
A feature of the AIRIUS SYSTEM is its flexibility. Hardware that may be used to hang
the unit includes, but is not restricted to: Hooks, chains, cables, carabineers, bridal
rings, beam clamps and bolts. Roof structure, building construction, electrical
outlets/service, and accessability will define the appropriate hardware for each install.
After insuring the AIRIUS SYSTEM is firmly attached and after REMOVING YOUR
HANDS FROM THE UNIT, ONLY THEN is it safe to plug the unit in to the power
source using the approved plug to confirm function and connectivity.
NOTE:
SECURE the power cord to the ceiling structure as added security. The Cord will
act as a safety leash and by securing it the possibility of the plug accidentally coming
out of the outlet in the future is greatly reduced. A 50 lb (20 Kilo) rated Zip-T, several
wraps of electrical tape, or mechanics wire are examples of methods of securing the
Airius Operating Manual 12/10/06 11:40 Page 6