Antari X FOGGER User Manual - page 3

Danger of Burns

! For adult use only.  Never leave the unit running 

unattended.  

! Never aim the output nozzle directly at people.

! Fog machine output area is very hot.  Avoid coming within 

60 cm of the output nozzle during operation.

! Locate the fog machine in a well-ventilated area.  Never 

cover the unit's vents.  In order to guarantee adequate 

ventilation, allow a free air space of at least 20 cm around 

the sides and top of the unit.

! Never aim the output nozzle at open flames.

! If the supply cord is damaged, it must be replaced by 

manufacturer or its service agent or similarly qualified 

personnel in order to avoid a hazard.

! The output nozzle becomes very hot during operation 

0

(300 C).  Keep flammable materials at least 50 cm away 

from the nozzle.

! Always allow your ANTARI X Fogger  to cool down before 

attempting to clean or service it.

 Danger of Explosion

! Never add flammable liquids of any kind (oil, gas, perfume) 

to the fog liquid.

! Use only the high-quality, water-based ANTARI fog liquid. 

Other fog liquids may cause clogging or "spitting".

! Always make sure there is sufficient liquid in the fog liquid 

tank.  Operating this unit without liquid will cause damage 

to the pump as well as over-heating of the heater.

! If your ANTARI Fog Machine fails to work properly, 

discontinue use immediately.  Drain all fog liquid from the 

tank, pack the unit securely (preferably in the original 

packing material), and return it to your ANTARI dealer for 

service.

! Always drain tank before mailing or transporting this unit.

! Never drink fog liquid.  If it is ingested, call a doctor 

immediately.  If fog liquid comes in contact with skin or 

eyes, rinse thoroughly with water.

Important:  

Pay attention to all warning labels and instructions printed on 

the exterior of your ANTARI X Fogger.

Unpacking

&

Inspection

Open the shipping carton and verify that all equipment 

necessary to operate the system has arrived intact. 

Before beginning initial setup of your ANTARI Fog Machine, 

make sure that there is no evident damage caused by 

transportation.  In the event that the unit's housing or cable is 

damaged, do not plug it in and do not attempt to use it until