Antari X FOGGER User Manual - page 5
any one's face. Whatever installation method you choose, do
not allow the unit to have more than a 15 degree angle of
inclination.
Important:
Always monitor tank fluid level as you are fogging. Running
a fog machine with no fluid can permanently damage the
unit.
If you experience low output, pump noise or no output at all,
unplug immediately. Check fluid level, the external fuse,
control module connection, and power from the wall. If all of
the above appears to be O.K., plug the unit in again. If fog
does not come out after holding the control module button
down for 30 seconds, check the hose attached to the tank to
make sure there is fluid going through the hose. If you are
unable to determine the cause of the problem, do not simply
continue pushing the control module button, as this may
damage the unit. Return the machine to your ANTARI dealer
immediately.
Control
Module
Operation
! X-10: 10 meter wired multi-function remote control module
with 5-pin XLR connector for ANTARI X Series models X-
310, X-510, X-515, X-530. Its interface allows the operator
to customize fog machine functions by adjusting fogging
duration, interval and volume. Its LCD displays current
operating parameters, which are automatically stored in
non-volatile memory, allowing the machine to be powered
down without losing function settings. Instructions below:
1.Via the Function key, you can adjust the desired settings.
Pressing the
Function key will cycle through different
options including Volume, Timer, Heat & Fan. The Enter
(Volume) Key is used to select the desired option. To adjust
fog output volume setting, simply go into Volume option.
Adjust the volume percentage (within the range of 1% to
nonstop burst) by means of Up / Down keys. To adjust
timer setting, go into Timer option. Cycle through Interval
(within the range of 1 to 900 seconds), Duration (within the
FUNCITON
VOLUME
ESC
ENTER
ON / OFF
TIMER
MANUAL