Antari X FOGGER User Manual - page 4
after contacting your ANTARI dealer for assistance.
Setup
! Remove all packing materials from shipping box. Check
that all foam and plastic padding is removed, especially in
the nozzle area.
! Place fog machine on a flat surface and remove fog liquid
tank cap.
! Fill with only ANTARI Fog Fluid. ANTARI X Fogger only
works with uncontaminated ANTARI Fog Fluid. Other
fluids may cause spitting and serious clogging problem and
could result in the production of an unhealthful fog. The use
of other fluids voids the warranty of the ANTARI X Fogger.
When filled, place cap back on liquid tank.
! Firmly attach the control module cable to the connector
inside the rear chamber of the machine.
WARNING:
Use of any fluid other than ANTARI fog fluid or
modification or attempted to unauthorized repair of the X
Fogger will immediately invalidate the warranty.
Operation
! The plug is positioned that the plug is accessible when used
machine.
! Plug power cord into a grounded electrical outlet. Turn
power switch on rear of unit to " ON" position. Warm-up is
complete when the display on control module shows "
Ready to Fog."
! To emit fog, press the appropriate button on the control
module for the desired length of time.
! The control unit's display will cycle " Warming up" and "
Ready to Fog " as the machine re-heats to the proper
operating temperature.
! When the fluid is running low, the LED inside the tank
chamber starts blinking for two minutes and then stop
operation to protect the pump from running dry..
! Always monitor liquid level to prevent interrupted
operation.
! For further information on operating your ANTARI X
Fogger, see the section titled, "Control Module Operation"
on page 4.
Caution: "Visibility during operation is reduced"
If your model includes a mounting bracket designed for
overhead installation, it may be installed at floor level or
suspended overhead. If the unit is to be mounted using the
bracket, it is important that the fog does not shoot directly at