Antec MINUET II User Manual - page 3
3
POWER/LED CONNECTIONS
The power supply is an ATX12V form factor power supply. It has a single 20-pin Main Power
Connector, and a 4-pin +12V Power Connector for the motherboard. It is backwards
compatible to previous ATX form factor power supplies. If your motherboard does not support
the +12V 4-pin Power Connector, you can still use this power supply. It also comes with three
4-pin Peripheral Power Connectors and one 4-pin Floppy Drive Power Connector for your
drives.
1. Connect the 20-pin ATX power connector (and +12V connectors if appropriate) to your
motherboard.
2. Power LED (labeled POWER LED) connector is located behind the Reset connector.
3. Power Switch (labeled POWER SW) connects to the PWR connector on the motherboard.
4. Hard Drive LED (labeled H.D.D. LED) connects to the IDE connector.
CONNECTING THE USB PORTS
You will find a single 10-pin connector on a cable attached to the front USB ports. This is an Intel
standard connector which is keyed so that it can't be accidentally reversed as long as it is
connected to a proper Intel standard motherboard header. Connect the 10-pin connector to your
motherboard headers so that the blocked pin fits over the missing header pin.
Note: Please check your motherboard manual for your USB header pin layout and make sure it
matches the attached table. If it does not match this Intel standard, please call Antec customer
support at (800) 22ANTEC (North America) or at +31 (0) 10 462-2060 (Europe) to buy a USB
adapter. This adapter will allow you to connect the front USB to your motherboard on a
pin-by-pin basis.
CONNECTING THE IEEE 1394 (FIREWIRE®, I.LINK®) PORT
You will find a single 10-pin connector on a cable attached to the front IEEE 1394 connection.
This is an Intel standard connector, which is keyed so that it can't be accidentally reversed as long
as it is connected to a proper Intel standard motherboard header. Connect the 10-pin connector
to your motherboard header so that the blocked pin fits over the missing header pin.
Note: Please check your motherboard manual for your IEEE 1394 header pin layout and make
sure it matches the attached table. If you intend to connect the front FireWire port to an IEEE
1394 add-on card that comes with an external-type IEEE1394 connector, please call Antec
customer service at (800) 22ANTEC (North America) or +31 (0) 10 462-2060 (Europe) to buy an
adapter. This adapter will allow you to connect the front IEEE 1394 port to the external-type connector..
Pin
Signal Names
Pin
Signal Names
1
3
5
7
9
2
4
6
8
10
USB Power 1
Negative Signal 1
Positive Signal 1
Ground 1
Key (No Pin)
USB Power 2
Negative Signal 2
Positive Signal 2
Ground 2
Empty Pin
Intel Standard USB Header Pin Layout
1
2
9
10