Antec MINUET II User Manual - page 5
5
9. To install the internal 3.5" device, find the two mounting prongs
on one side of the bay. With one hand holding the device at a
45-degree angle with the bottom side up, align the two screw
holes on one side of the device with the prongs and slide the
device into the bay. (See picture 7)
10. Fasten the other side of the device to the two tabs with the screws
provided. (See picture 8.)
11. When sliding the Cage back into the case, work slowly and
carefully to ensure that the front panels of the external devices
align properly with the holes provided for them in the bezel.
12. Connect power to each of the devices.
COOLING SYSTEM
The TriCool fan
The case includes one 80mm TriCool fan installed in the side of the
chassis. This fan has a three-speed switch that lets you choose between
quiet, performance, or maximum cooling. We set the default fan speed
to "Medium". (See specifications below) The fan is installed so that
the air is blowing out of the case. Connect a large 4-pin connector
from the power supply to the male 4-pin connector on the fan. Note:
The minimum voltage to start the fan is 5V. We recommend our users
to set the fan speed to High if you choose to connect the fan to a fan
control. A fan control device regulates the fan speed by varying the
voltage to it. The voltage may start as low as 4.5V to 5V. Connecting
a TriCool set on Medium or Low to a fan-control device may result in
the fan not being able to start. The already lowered voltage from the
fan control device will be further reduced by the TriCool circuitry
below 5V.
Specifications:
Size:
80 x 80 x 25.4mm
Rated Voltage:
12V
Operating Voltage: 10.2V ~ 13.8V
Picture 5
Picture 6
Picture 7
Picture 8
Picture 4
Static
Pressure
3.04 mm-H
2
O
(0.12 inch-H
2
O)
Speed
Input
Current
Air Flow
Acoustical
Noise
Input
Power
High
2600 RPM
0.2A
(Max.)
0.96 m³/min.
(34 CFM)
30 dBA
2.4 W
Medium
2000 RPM
Low
1500 RPM
0.15A
0.1A
0.74 m³/min.
(26 CFM)
0.55 m³/min.
(20 CFM)
1.79 mm-H
2
O
(0.07 inch-H
2
O)
1.0 mm-H
2
O
(0.03 inch-H
2
O)
24.3 dBA
18.05 dBA
1.8 W
1.2 W