Antec MINUET II User Manual - page 4
CONNECTING THE AUDIO PORTS
Locate the internal audio connectors from your motherboard or sound card. Consult your
motherboard or sound card manual for the pin-out positions.
1. Microphone Signal Pin: Connect the MIC-IN connector to this pin.
2. Microphone Power: Connect the MIC-POWER connector to this pin.
3. Ground Pin: Connect the GROUND connector to this pin.
4. Front Right Speaker Out Pin: Connect the R-OUT connector to this pin.
5. Front Right Speaker Out Pin: Connect the L-OUT connector to this pin.
6. Rear Right Speaker Out Pin: Connect the R-RET connector to this pin.
7. Rear Left Speaker Out Pin: Connect L-RET connector to this pin.
Note: If your motherboard is not equipped with REAR SPEAKER output, it is not necessary to
use the R-RET and L-RET connectors.
DRIVE INSTALLATION
Minuet incorporates a rapid-release Flip Up Drive Cage for easy drive installation. The Cage
includes three drive bays: one external 5.25", one external 3.5", and one internal 3.5".
1. Before installing the external drives, remove the external drive bay covers.
a. To remove the external 5.25" drive bay cover, face the front of the case and use your left hand
thumb to press firmly on the LEFT or outside edge of the left bay cover to release it.
(See picture 3)
b. To remove the external 3.5" drive bay cover, face the front of the
case and use your right hand thumb to press firmly on the
RIGHT or outside edge of the right bay cover to release it.
(See picture 4)
2. Lift up and slide the drive cage from the case.
3. Place the cage upside down on a flat surface.
4. Note: You must install the external devices first, before installing
the internal 3.5" device.
5. Slide the external 5.25" device into the drive cage from the front. Since the drive cage is upside
down, your drive should be too so that it will be properly orientated once the cage is installed
in the Minuet II.
6. Align the bottom rear screw holes (one at each side) on the device with the two screw holes
(the pair closest to the front of the cage) on the cage and fasten the device with the screws
provided. (See picture 5)
7. Slide the external 3.5" device into the drive cage from the front. Since the drive cage is upside
down, your drive should be too so that it will be properly orientated once the cage is installed
in the Minuet II.
8. Align the bottom rear screw holes (one at each side) on the device with the two screw holes
on the cage and fasten the device with the screws provided. (See picture)
Pin
Signal Names
Pin
Signal Names
1
3
5
7
9
2
4
6
8
10
TPA+
Ground
TPB+
+12V (Fused)
Key (No Pin)
TPA–
Ground
TPB–
+12V (Fused)
Ground
4
Standard Pin Assignment for IEEE 1394 Connector
1
2
9
10
Picture 3