Audio Analogue Crescendo Owner's Manual - page 12
12
UNPACKING AND CHECKING Crescendo tuner/usbdac PACKAGE
Carefully open the package to avoid damaging the content. The package should contain:
•
1 Crescendo tuner/usbdac
•
1 remote controller
•
1 power cord
•
2 AAA batteries
•
1 instruction manual
•
1 AM 300Ohm antenna
•
1 FM 75Ohm antenna
•
1 USB cable
If one of the items listed above is missing, please contact your Audio Analogue retailer. After extracting the smallest items from the
package, pull out the unit carefully. Separate the package from the anti-shock expanded-foam protections. If batteries are not already placed in the
remote controller battery slot, open the slot, insert batteries according to the indicated polarity, then close the battery slot.
APERTURA E ISPEZIONE DELL’IMBALLO
Aprire la scatola di cartone con cautela per non danneggiare il contenuto. L’imballo deve contenere:
•
Un Crescendo tuner/usbdac
•
Un telecomando
•
1 Cavo di alimentazione
•
Due batterie AAA
•
Questo manuale
•
1 Antenna AM 300Ohm
•
1 Antenna FM 75Ohm
•
1 Cavo USB
Se qualcuno degli oggetti sopra elencati dovesse mancare, contattate il Vostro rivenditore Audio Analogue di fiducia.
Dopo avere estratto le parti di minori dimensioni, estrarre con cautela l’apparecchio dall’imballo. Separare l’imballo dalle imbottiture antiurto in
schiuma espansa. Se le batterie non si trovano già all’interno del telecomando, aprire il coperchio del vano portapile del telecomando ed inserirle
nelle posizioni corrette; quindi chiudere il coperchio del vano portapile.
WHERE TO PLACE THE Crescendo tuner/usbdac
Place the unit on a flat and hard surface and in a well-ventilated place. Avoid exposing the unit to high temperatures and moisture. Be sure that the
ventilation grids placed on the bottom and on the back panel of the unit are not obstructed.
SCELTA DEL LUOGO IN CUI POSIZIONARE IL Crescendo tuner/usbdac
L’apparecchio deve sempre essere sistemato in orizzontale su una superficie dura e piana. Si prega di assicurare sempre una opportuna
ventilazione ed evitate di esporre l’apparecchio ad elevate temperature e umidità. Sul fondo dell’apparecchio e nel pannello posteriore, sono
presenti dei fori per la ventilazione, assicurarsi che il posizionamento scelto non ostacoli il passaggio dell’aria attraverso tali fori.
PLUGGING AND CONNECTING THE Crescendo tuner/usbdac
Before connecting Crescendo tuner/usbdacto other equipment, please be sure they are all (your PC/MAC too) unplugged from wall
outlets. First of all, connect the antennas to their inputs. Unroll the FM antenna as much as possible. Be sure the main switch is in the OFF position.
Connect Crescendo tuner/usbdacanalog outs to an integrated amplifier or preamplifier line inputs. Connect the Crescendo
tuner/usbdacdigital output to a DAC converter if available, and connect your PC/MAC USB port to the Crescendo
tuner/usbdac USBDAC input via the USB cable.
Then plug Crescendo tuner/usbdacand all the other units (the PC/MAC too) to the main power.
COLLEGAMENTO DEL Crescendo tuner/usbdac
Prima di collegare Crescendo tuner/usbdacad altri apparecchi, verificare che essi, compreso il PC/MAC, siano scollegati dalla rete
elettrica e che l’interruttore principale del Crescendo tuner/usbdacsia in posizione OFF. Collegare le antenne ai relativi connettori.
Disporre l’antenna FM in modo che risulti il più possibile distesa. Collegare le uscite del Crescendo tuner/usbdacad un ingresso linea
dell’amplificatore integrato o del preamplificatore e collegare l’uscita digitale all’ingresso dell’eventuale convertitore DA. Connettere quindi la porta
USB del vostro PC/MAC all’ingresso USBDAC con il cavo USB. Collegare quindi il cavo di alimentazione fornito in dotazione al Crescendo
tuner/usbdacall’apposita vaschetta e collegare tutti gli apparecchi, compreso il Crescendo tuner/usbdace il PC/MAC alle
prese di rete.