Audio Authority ADX-0808 Installation And Operation Manual - page 13
13
Appendix A: Serial Commands
Description
Command Structure
Example
Command(s)
Example Output
Result
Switching and Zone/Source Related
Switch a zone
output to a
source input.
[CO##I##]
[CO1I2]
(CO1I2)
Zone output 1 is connect to
source input 2.
Switch all zones
to a single input
source.
[CXI##]
[CXI4]
(CXI4)
All zone outputs are
connected to source input 4.
Switch to
a favorite
zone/source
configuration.
[CF##]
[CF3]
(CF3)
All zones that are a member
of favorite 3 will be set
to the predefined source
connections.
Switch a group
of zones to the
specified source.
[CG##I##]
[CG1I3]
(CG1I3)
All zones that are a member
of group 1 are switched to
source 3.
Query output
zone.
[QO##]
[QO8]
(BO8L0R0)
(EO8B1L0)
(EO8B2L0)
(EO8B3L0)
(EO8B4L0)
(EO8B5L0)
(EO8B6L0)
(EO8B7L0)
(EO8B8L0)
(EO8B9L0)
(EO8B10L0)
(VUMO8)
(TO8B0T0)
(VO8R-12)
(CO8I4)
(NO8”Zone 8 Name”)
Returns the current settings
related to the output zone,
including balance, EQ levels
for each band, muting, tone,
volume level, current source
selection, and name.
Name an output
zone.
[NO##”@”]
(Where @ represents up to
16 characters)
[NO3”Mud Room”]
(NO3”Mud Room”)
Zone 3 is named “Mud Room”
Name an input
source.
[NI##”@”]
(Where @ represents up to
16 characters)
[NI3”Radio 1”]
(NI3”Radio 1”)
Source 3 is named “Radio 1”
Digital Signal Processing
Adjust zone
balance.
[BO##L##R##]
[BO2L-3R0]
(BO2L-3R0)
Zone 2 output level for the
left channel is attenuated 3
dB, while the right channel is
set flat.
Adjust zone
equalization.
[EO##B##L##]
[EO12B2L-4]
(EO12B2L-4)
Zone 12 equalizer band 2 is
set to -4 dB.
Adjust zone tone
control.
[TO##B##T##]
[TO2B-3T9]
(TO2B-3T9)
Zone 2 output tone control
is set to attenuate bass 3 dB
and amplify treble 9 dB.
Set a zone
output volume
level.
[VO##R##]
[VO1R-10]
(VO1R-10)
Zone 1 output volume level
is attenuated 10 dB from the
maximum level.
Set all zones to
an output volume
level.
[VXR##]
[VXR-30]
(VXR-30)
All zone outputs are set to
-30 dB.
Un-mute a zone
output.
[VUMO##]
[VUMO3]
(VUMO3)
Zone 3 output is un-muted
and set back to the previously
set volume level.
Mute a zone
output.
[VMO##]
[VMO1]
(VMO1]
Zone 1 output is muted.