Audio Authority ADX-0808 Installation And Operation Manual - page 14
14
Network Settings Adjustment
Query current
network
(Ethernet)
settings
[QE]
[QE]
(DHCP1)
(IP0.0.0.0)
(NM0.0.0.0)
(GW0.0.0.0)
(MAC00-00-5E-A8-
00-D3)
DHCP status, IP address,
subnet mask, gateway, and
MAC address are displayed by
this command.
Enable or disable
dynamic host
configuration
protocol (DHCP).
[DHCP#]
[DHCP1]
[DHCP0]
(DHCP1)
(DHCP0)
DHCP is enabled (1) or
disabled (0). It is not possible
to statically set address while
DHCP is on.
Define the static
IP address.
[IP###.###.###.###]
[IP192.168.0.212]
(IP192.168.0.212)
Set the IP address to the
specified value.
Define the
default gateway.
[GW###.###.###.###]
[GW192.168.0.2]
(GW192.168.0.2)
Set the default gateway for
accessing computers outside
of the subnet.
Define the
subnet mask.
[NM###.###.###.###]
[NM255.255.255.0]
(NM255.255.255.0)
Set the subnet mask, which
determines the computers
that can be accessed without
traveling through the
gateway.
Serial Settings Adjustment
Set the serial
baud rate.
[SB#]
[SB0]
[SB1]
[SB2]
(SB0)
(SB1)
(SB2)
Baud rate is set to 9600 (0),
19200 (1), or 115200 (2)
Front Panel Interface Adjustment
Query front panel
interface lockout
[QFPL]
[QFPL]
(FPL0)
(QFPL)
Returns whether the front
panel interface is locked out
(1) or unlocked (0)
Enable or disable
front panel
interface lockout
[FPL#]
[FPL0]
[FPL1]
(FPL0)
(FPL1)
Front panel interface is locked
out (1) or unlocked (0)
Query front panel
IR lockout
[QIRL]
[QIRL]
(IRL0)
(QIRL)
Returns whether the front
panel IR is disabled (1) or
enabled (0)
Enable or disable
front panel IR
lockout
[IRL#]
[IRL1]
[IRL0]
(IRL1)
(IRL0)
Lock out front panel IR (1) or
allow it to operate (0)
Set VFD
backlight and
LED dimming
level
[SD#]
[SD1]
(SD1)
The VFD and LED brightness
level is set (0-3 are valid
levels)