B&D Diamond Series Instructions For The Use - page 11
10
114A2991
INSTALL THE DOOR CONTROL
Locate door control where the garage door is visible, away
from door and door hardware and out of the reach of
children. Mount at least 1.5m (5 feet) above the floor.
Serious personal injury from a moving garage door may
result from misuse of opener. Do not allow children to
operate the door control or remote control transmitter.
Fasten the caution label permanently to the wall near the
door control as a reminder of safe operating procedures.
There are 2 screw terminals (1) on the back of the door control
(2). Strip about 6mm (1/4") of insulation from bell wire (4).
Separate wires enough to connect the white/red wire to RED
terminal screw 1 and the white wire to WHT terminal screw 2.
Fasten the door control to an inside garage wall with sheet metal
screws (3) provided. Drill 4mm (5/32") holes and use anchors if
installing into drywall. A convenient place is beside the service
door and out of reach of children.
Run the bell wire up the wall and across the ceiling to the garage
door opener. Use insulated staples to secure wire. Connect the
bell wire to the terminals as follows: white/red to red and white to
white (5).
OPERATION OF THE MULTI-FUNCTION DOOR CONTROL
Press the white square to open or close the door. Press again to
stop the door while it is moving.
Light Feature:
Press the Light button to turn the opener light on or
off. If you turn it on and then activate the opener, the light will remain
on for 2-1/2 minutes. Press again to turn it off sooner. The Light
button will not control the opener lights when the door is in motion.
Lock Feature:
Prevents operation of the door from portable
remote controls. However, the door will open and close from the
Door Control push button, the Outside Keylock and the Keyless
Entry Accessories.
• To Activate: Press and hold the Lock button for 2 seconds. The
push button light will flash as long as the Lock feature is on.
• To turn off: Press and hold the Lock button again for 2 seconds. The
push button light will stop flashing. The Lock feature will also turn off
whenever the
PROG button on the control panel is activated.
LOCK
LIGHT
2
1
RED WHT
8
8
kg
1
9
o
180s
120s
60s
5
7
1
3
3
2
9
5
7
1
3
kg
kg
2
1
RED WHT
LOCK
LIGHT
1
2
7
9
4
4
3
5
6
REMOTE CONTROL WALL MOUNT (OPTIONAL)
1. Locate wall mount bracket at least 1.5m above the floor.
2. Attach to the wall with 2 x ø 3.5 max flat head screws (not
provided).
3. Slide remote control onto wall mount bracket.
NOTE: Tightening the wall mount screws will reduce clearance
between bracket and wall.