B&D Diamond Series Instructions For The Use - page 7
6
J-STYLE TILT DOOR / ONE-PIECE DOOR WITHOUT TRACK
• With the door fully open and parallel to the floor, measure the
distance from the floor to the top of the door.
• Using a stepladder as a support, raise the top of the opener to
this height.
• The top of the door should be level with the top of the motor unit.
Do not position the opener more than 50mm above this point.
HANG THE OPENER
The opener must be securely fastened to a structural
support of the garage.
Two representative installations are shown. Yours may be
different. Hanging brackets (1) should be angled (Figure A) to
provide rigid support. For concrete ceiling mount (Figure B), use
concrete anchors (4) provided.
On each side of opener measure the distance from the opener to
the structural support (or ceiling).
Cut both pieces of the hanging bracket to required lengths. Do
not bend at the bracket holes. Drill 4.5mm pilot holes in the
structural supports (or ceiling). Attach ends of brackets to
supports with wood screws (2).
Lift opener and fasten to hanging brackets with screw and lock
nut (3). Check to make sure rail is centred over the door. Remove
25mm board. Operate door manually. If door hits the rail, raise
header bracket.
A
2
1
1
3
B
4
2
1
3
5
4
2
3
4
2
3
3
C
2
1
114A2991
ATTACH EMERGENCY RELEASE ROPE & HANDLE
Thread one end of rope (1) through hole in top of red handle so
"NOTICE" reads right side up as shown (3). Secure with an
overhand knot (2). Knot should be at least 25mm (1") from end
of the rope to prevent slipping.
Thread other end of rope through hole in release arm of the
outer trolley (4). Adjust rope length so that handle is 1.8m
(6 feet) above the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut rope, heat seal cut end with a
match or lighter to prevent fraying.
CONNECT ELECTRIC POWER
Do not attempt to operate your opener until instructed
during the travel limits programming procedure. IT WILL
NOT RUN. (See Adjustment section.)
Connect the opener to a mains which is properly EARTHED
(and as specified by local code).
Connect the door opener only to an outlet located near by the
opener.
INSTALL THE LIGHT AND LENS
Install a 40 watt maximum (240V, ESRC) light bulb in the socket
(1). Hinge the bottom of the lens (2) onto the cover from left of
the hinge bars (3) as shown. Close the lens by gently squeezing
the upper corners and inserting the tabs (4) into slots on the
cover (5).
To change bulb, squeeze the upper corners of the lens to
disengage tabs. The lens will drop open, remaining hinged at
bottom.
The light will turn on and remain lit for 2-1/2 minutes when
power is connected. After 2-1/2 minutes it will turn off.
2
3
4
NOTICE
2
1
4
2
4
5
5
1
3