B&D Diamond Series Instructions For The Use - page 3
2
DOOR TYPES
A. One-Piece Door with Horizontal Track Only
B. Sectional Door with Curved Track:
See Page 5 – Connect Door Arm to Trolley.
C. J-Style Tilt Door / One-Piece Door without Track
A
B
C
TOOLS NEEDED
2
1
11mm, 13mm
11/13mm
10mm, 8mm,
4,5mm, 4mm
HARDWARE PROVIDED
(1) Hex Bolt (4)
(2) Clevis Pin (2)
(3) 8mm Carriage Bolt (2)
(4) Wood Screws (6)
(5) Sheet Metal Screws (2)
(6) Clevis Pin 8 x 25mm (1)
(7) Rope
(8) Handle
(9) Insulated Staples (10)
(10) Anchor (2)
(11) Concrete Anchor (6)
(12) Lock Washer (6)
(13) Hex Nut (6)
(14) Ring Fastener (4)
(15) Rail Grease (1)
(16) Lock Nut (1)
(17) Metric Tapping Screw (2)
(18) Hex Screw (3)
(19) Flat Washer (2)
(20) Stop Bolt
(21) Spring Tensioner Nut (1)
(22) Master Link (1)
(23) Cariage Bolt, Front
Bracket (1)
(24) Transmitter Wall Mount
Bracket (1)
(25) Clevis PIn 8 x 32mm (1)
10
7
9
3
4
5
6
12
13
8
NOTICE
11
2
15
14
17
1
16
18
19
20
21
22
23
25
24
BEFORE YOU BEGIN:
1. Look at the wall or ceiling above the garage door. The header
bracket must be securely fastened to structural supports.
2. Do you have a finished ceiling in your garage? If so, a support
bracket and additional fastening hardware (not supplied) may
be required.
3. Do you have an access door in addition to the garage door? If
not, Modell T7012 Emergency Access Device is required.
COMPLETED INSTALLATION
As you proceed with the assembly, installation and adjustment
procedures in this manual, you may find it helpful to refer back to
this illustration of a completed installation.
1
2
3
12
4
6
9
8
10
11
13
14
7
15
10
5
(1) Header Sleeve
(2) Idler Pulley Bracket
(3) Trolley
(4) Rail
(5) Chain/Belt
(6) Hanging Bracket
(7) Power Cord
(8) Opener
(9) Light Lens
(10) Manual Release
Rope & Handle
(11) Curved Door Arm
(12) Straight Door Arm
(13) Door Bracket
and Plate
(14) Header Bracket
(15) Trolley Release Arm
114A2991