B&D Firmadoor Series Installation Instructions Manual - page 4
PART NO: 51621. REVISION 6 - OCTOBER 2016
1.2 fastener recommendations for fitting garage doors
important information on fasteners
The installer must select and use fasteners appropriate to the material into which they are being fixed.
important notes
1. For installation to materials not covered in the above chart, the installer should seek expert advice from a
qualified builder.
2. Minimum length of fastener does not exclude use of longer lengths. Decision must be made by fitter to ensure
adequate strength.
3. Recommendations for old materials or materials not in good condition are not included. If in doubt about the
strength of the material seek specialist advice.
4. Fasteners for brackets in masonry should be at least 5/16” x 2.5” long or metric equivalent.
5. HEBEL Fischer type fastener should be installed 150mm from edge of blocks. Minimum overlap of door should be
approximately 115mm (S1), 110mm (S3) and 90mm (Panelift). Add 50mm more if mounted on panels instead of
blocks.
material
fastener type(s)
diameter
or type
length of fastener
(see note)
New Solid Brick
Coach Bolts (Hex Lag Screw)
- combined with wall plugs
5/16”
x
1½”
3/8”
x
2”
Macplugs (wall plugs) to suit above
5/16”
x
50mm
3/8”
x
60mm
HLC Sleeve Anchors (Dyna Bolts)
12mm
x
55mm
New Hollow Brick
HRD-VGK or HGK-VGS (Hex Head) Frame Anchors
10mm
x
60mm
New Solid Concrete
Coach Bolts (Hex Lag Screw)
- combined with wall plugs
5/16”
x
1½”
3/8”
x
2”
Macplugs (wall plugs) to suit above
5/16”
x
50mm
3/8”
x
60mm
HLC Sleeve Anchors (Dyna Bolts)
12mm
x
55mm
Aerated Concrete
e.g. (HEBEL)
Fischer Nylon Twist Lock Anchor Type
GB 14
14mm
x
85mm
Steel Framing
e.g. BHP Framing
(with rear access)
Hex Head Bolt Zinc Plated,
Hexagon Nuts Zinc Plated,
Washers Zinc Plated
5/16”
x
1”
3/8”
x
1”
10mm
x
25mm
12mm
x
25mm
Heavy Gauge Steel
Hex Head Tek
14-20 x
22mm
Light Steel Framing
e.g. BHP House
Framing
(no rear access)
Heavy Duty Kap Toggle
10mm
x
100mm
12mm
x
100mm
Hex Head Tek
6-10
x
20mm
New Timber
Coach Bolts (Hex Lag Screw)
5/16”
x
1½”
3/8”
x
2”
Hex Head Tek
14-10
x
50mm
4
Firmadoor
®
Series 1 Installation Instructions